Rolling Plains Correctional Facility
Close

We will be exhibiting at MRCA on October 21-23. Visit us at Booth #326 or Schedule an Appointment HERE!

Call Us

800-575-8966

Haskell, TX

Rolling Plains Correctional Facility

Contractor:

Flores Enterprises
Lorena, TX

Project Location:

Rolling Plains Correctional Facility
Haskell, TX

Products Used:

  • Evercaulk FG
  • Everseal
  • Everseal PMP
  • Evercoat Glaze
  • Evercoat EC

Challenge:

The customer faced a complex repair job on a building with many large roof protrusions during a period of cold and rainy weather, and short daylight hours. Flores Enterprises was informed that the building had hundreds of leaks.

Project Description:

Flores began by removing trash and debris from the roof and gutter system, including a large amount of nesting material (long grass) which was clogging downspouts. An abandoned water line that traversed the entire length of the roof had to be removed, along with countless unused fasteners and old garden hoses which hadn’t been used in years. Loose and missing fasteners throughout the roof were replaced and/or tightened, and a rust inhibiting primer was then applied to the few surface rust areas on the roof. Cracked ribs were sealed with a combination of butyl tape and Evercaulk FG.

Evercaulk FG Brush application to vertical seams was accomplished via pumping to the roof from 55 gallon drums and extruding onto the seams with a custom-made application tip. Because of the numerous HVAC and vent units that would require servicing, three “stitch screws” per linear foot of horizontal seam were installed to keep the roof seam from moving with inevitable foot traffic. Horizontal seams were sealed by spraying Evercaulk FG Brush into them and then brushing the sealant into the gap. This was followed by spraying a thick layer of Evercaulk FG over the horizontal seam to add strength to the seal.

Flashing areas were sealed with Evercaulk FG. Any flashing areas that were subject to extreme movement were sealed with Everseal. Sealant was applied to all bolts, and protrusions were sealed with a combination of Everseal, Everseal PMP, and Evercaulk FG. Everseal and Everseal PMP were used for areas that would be subject to small amounts of ponding water, such as in front of large HVAC units. Evercaulk FG was used where water would not stand and on the sides and back of the large HVAC units.

Finally, two coats of Evercoat Glaze were applied to the 16 skylights located throughout the roof, and two coats of Evercoat EC light gray were applied to the entire roof.

When the job was completed, the roof did not have a single leak.

Previous Article Rialto Police Department
Next Article Camden County Library
Print

Featured Products

- view all products -

Eco-Level

Eco-Level is designed as a fast cure, extremely durable self-leveling compound for the elimination of ponded areas on all types of flat roofs. The addition of EverThix fibers will allow Eco-Level to also be used for the installation of roof crickets.

FiberFlash

A high quality, plasticizer free, water-based, 100% acrylic, fiber-reinforced, highly flexible seam sealer for roof seams. Unique formulation allows the product to be pumpable and still maintain a high film build.

Evercoat OnePass

100% acrylic high build roof coating that can be applied at 50 wet mils in one coat. Has quick set technology allowing the material to handle a light rain as soon as 30 minutes. Sag resistant allows up to 50 wet mils on a vertical surface.

Evercoat OnePass HT

Industry leading High Tensile Strength high-build roof coating. 100% acrylic roof coating that can be applied at 50 wet mils in one coat. Has quick set technology allowing the material to handle a light rain as soon as 30 minutes. Sag resistant allows up to 50 wet mils on a vertical surface.

Copyright © 2024 Everest Systems Co.   |   Admin Login